If you would like to change the scent of paraffin wax in your TherabathPRO or Spa Petite , follow these instructions.
Start the day prior to when you would like to use the bath again.
Unplug the unit. Remove the lid and grille. Allow the paraffin to solidify overnight.
After the paraffin is solid, plug the unit in for a few minutes, or just until the cake of paraffin loosens from the sides and bottom of the unit. Then unplug the unit. DO NOT leave an empty unit plugged in. To do so will cause the unit to get excessively hot, causing possible damage to the unit.
Press down firmly on one end of the paraffin, tipping the opposite end up. Then lift out the cake and place it on paper towels.
Blot up any remaining paraffin in the tank with paper towels. If any solidified paraffin remains inside or on the outside of the unit, soften carefully with a hair dryer and remove with a paper towel.
Clean the inside and outside of the unit with an all-purpose cleaner. Thoroughly wipe the unit dry.
WR Medical Electronics Co. 1700 Gervais Avenue, Maplewood, MN 55109 USA.
Toll-free 800-321-6387; phone 651-604-8400; fax 651-604-8499. Hours: M-F, 8:00 am to 4:30 pm Central Time.
All content copyright 1998-2013 by WR Medical Electronics Co. All rights reserved. For trademark and patent information, please go to our legal notices page,
Last modified: May 15, 2013.